Sanmina · 3 months ago
Weld Quality Control Inspector -2nd Shift
Fremont, CA
Full-time
Onsite
Mid Level
$25/hr - $28/hr
4+ years expSanmina Corporation is a leading integrated manufacturing solutions provider in the Electronics Manufacturing Services market. They are seeking a detail-oriented Quality Control Inspector for their Fremont facility to ensure product acceptance through inspection of parts based on customer drawings and workmanship standards, as well as to assist in developing quality inspection methods and procedures.
Industrial EngineeringManufacturingSupply Chain Management
No H1B
U.S. Citizen Only
Responsibilities
Perform inspections to determine the quality of both metal components and electromechanical assemblies, visually and dimensionally, based upon internal and customer supplied workmanship standards and drawing specifications
Areas of inspection will include primarily machining, sheet metal fabrication, paint and weld, but may extend to clean room and final assembly inspection
Perform receiving inspection on incoming purchased components and raw materials
Determine and assist in developing methods and procedures for quality inspection and control
Apply final labels or markings as required to demonstrate product acceptance
Document and communicate any non-conformances identified during inspection activities
Perform calibration audits and support internal calibration activities
Complete daily reports of inspection activities
Visual acuity and manual dexterity required
Ability to sit, stand, walk, bend and lift up to 50 lbs
Qualification
Required
High School Diploma or college courses
Minimum of 4-6 years of quality assurance experience in a mechanical manufacturing environment
Experience with weld inspection HIGHLY DESIRED
Must have knowledge of GD&T drawings consistent with the latest revisions of the ASME standards
Ability to design and build fixtures for welding parts
Ability to read and interpret blueprints
Ability to pass a weld test
Knowledge of mechanical inspection and able to use inspection tools
Experience reading and interpreting Bill of Materials (BOM), workmanship standards and customer engineering specifications
Experience with basic inspection equipment and measurement such as, but not limited to bore gauge, caliper, micrometer, pin gauges, etc
Competent in word processing, spreadsheets, and data analysis
Effective oral and written communication skills
Must be flexible in regards to overtime availability and work with minimal supervision
Visual acuity and manual dexterity required
Ability to sit, stand, walk, bend and lift up to 50 lbs
This is an ITAR facility and applicant must be a US Citizen or a lawful permanent resident
Preferred
Experience as a CMM operator is a plus
Welding Certification is a plus, knowledge in robot weld, arc weld, spot weld
Company
Sanmina
Sanmina creates, manufactures, and repairs some of the most complex and innovative optical, electronic, and mechanical products.
10001+ employees
Funding
Current Stage
Late StageLeadership Team
Jon Faust
Executive Vice President & Chief Financial Officer
Recent News
2025-12-20
MarketScreener
2025-12-16
Company data provided by crunchbase