Apply on Employer Site

K2 Space Corporation · 3 months ago

Avionics Harness Technician

Los Angeles, CA

Full-time

Onsite

Entry Level

$24/hr - $35/hr

2+ years exp

K2 Space Corporation is building large, high-powered spacecraft for the next generation of space development. The Avionics Harness Technician will contribute to the design, development, and testing of avionics components, supporting the production and development of the K2 Mega-class satellite.

AerospaceMachinery ManufacturingManufacturingSpace Travel

No H1B

U.S. Citizen Only

Responsibilities

Fabricate wire harnesses from assembly drawings and electrical schematics

Assemble electromechanical assemblies and assist engineering with the development of production processes for first time builds

Follow work instructions / assembly procedures and document work performed through MES system and other tools

Work side-by-side with design and manufacturing engineering in a fast-paced environment

Route harnesses and support integration of electromechanical assemblies on the Mega-class satellite

Support production transition from engineering development and initial production to full rate production

Provide consistent process improvement feedback to engineering and production leadership

Qualification

Cable harness fabricationElectromechanical assemblyTestMeasuring toolsMS Office proficiencyIPC CertificationProblem-solving abilitiesCommunication skillsAdapt

Required

2+ years of experience in cable harness fabrication, assembly, or integration

Experience in a manufacturing setting, preferably in aerospace or electronics

Proficiency in MS Office suite, and shop floor management software

Demonstrate high level of ownership and problem-solving abilities

Able to set up and use a torque wrench and other hand tools such as: wrenches and safety wire pliers

Experience performing crimping, wire stripping, continuity testing, connector pin outs, routing, and tie wrapping

Experience using test and measuring tools (digital multimeter, caliper, micrometer)

Familiar with ERP and part traceability

Ability to adapt to changing work assignments under tight deadlines

Must be able to work extended hours and/or weekends as needed

Must be able to perform repetitive tasks such as bending or twisting, grasping, standing, lifting, pulling, pushing, stooping, stretching, carrying, and use hands to operate tools or machine controls

Must be able to lift and carry parts or equipment up to 50 lbs. Unassisted