Apply on Employer Site

L3Harris Technologies · 4 weeks ago

Quality Assurance Inspector NDT - RT/PT B

West Palm Beach, FL

Part-time

Onsite

Entry, Mid Level

$33.76/hr - $51.91/hr

L3Harris Technologies is dedicated to recruiting and developing high-performing talent in the defense industry. The NDT Quality Assurance Inspector B will utilize non-destructive testing techniques to ensure propulsion components meet quality control standards while collaborating with various departments to enhance inspection processes.

CommercialInformation TechnologyNational Security

No H1B

U.S. Citizen Only

Responsibilities

Provide technical guidance to interpret and implement nondestructive test requirements of developmental and production programs

Plan, coordinate and perform setups and inspections

Coordinate the training activities of other inspectors

Maintain appropriate Level II/III certification including required reliability demonstrations

Review and check complex procedures, drawings, work instructions and specifications to detect errors and interface with planning and/or engineering to recommend changes or revisions to improve efficiencies and methods

Identify nondestructive equipment design improvements

Work from written and verbal instructions, drawings, quality assurance data sheets, inspection methods and standards, nondestructive test specifications, general operating method and instructions from nondestructive test engineer to plan, setup, calibrate and perform capability checks and inspections on complex hardware

Use various precision measurement and optical equipment as required to determine acceptability and/or to describe defect size and location

Clean and otherwise process parts for NDT inspection processes

Select or devise appropriate holding devices and make recommendations for the modification of fixtures and tools to accommodate new, unusual, or irregularly shaped parts

Prepare detailed reports for inspections performed showing defect(s) revealed by the test as applicable

For all tests, accept or reject material based on interpretation of applicable standards

Fill out quality review orders or inspection discrepancy and correction records and mark parts, scope, or chart to show indications of defects revealed and to process unacceptable parts per procedures

Determine root cause(s) and work with others to establish effective corrective action to resolve

Responsible for entering pertinent information into all computer systems using the Point of Origin Material Review Board Procedures to ensure historical information is properly maintained

Complete and stamp all required documentation to acknowledge accepted/rejected hardware

Clean parts requiring minor cleaning after inspection using conventional means

Ensure the movement of parts is tracked through applicable systems and carry small parts to their next location or contact inside transportation for the movement of large parts

Assure equipment is maintained properly, that supply inventories are adequate and notify Procurement to initiate purchase orders when required

Perform over-inspections and audits as required to ensure flow of material through manufacturing process

Comply with environmental health and safety regulations and program requirements to ensure safe working conditions and to preserve a healthy environment

Perform other related work of a comparable or lower skill level as required

Qualification

NAS410 Level II CertificationNDT inspection experienceTechnical CertificationDimensional inspection methodsBasic computer skillsAlloy typesSoft skills

Required

Requires a minimum of a high school diploma or equivalent

Requires completion of a 2-3 Technical Certification or Trade School or equivalent

NAS410 Level II Certification in RT (Radiographic Testing - film or digital). PT (Penetrant Testing) certification is a plus

Requires well rounded knowledge of nondestructive test practices, procedures, and applications, and dimensional inspection methods

Requires ability to make applicable calculations according to established formulas and work from specifications and inspection standards and methods sheets

Requires basic knowledge of alloy type and material defect characteristics

Requires basic computer skills and the ability to navigate through manufacturing and quality systems

Experience and additional certification requirements will depend on the level filled