Apply on Employer Site

Eaton · 5 days ago

Inspector Tester C - 3rd Shift (Quality)

Waukesha, WI

Full-time

Onsite

Entry Level

$22.30/hr - $22.30/hr

1+ years exp

Eaton is a global technology leader in power management, and they are seeking an Inspector Tester C for their 3rd shift team. The role involves performing assembly inspection and electrical testing on transformers and regulators to ensure compliance with quality standards.

Electric Vehicle

No H1B

Responsibilities

Perform routine factory dielectric tests per established procedures, including OX (induced), QC impulse, and hipot (applied potential)

Perform routine factory loss tests per established procedures, including load loss (winding loss) & no-load loss (core loss)

Perform power factor, ratio, and resistance tests per established procedures

Perform operational tests on regulators as required

Perform continuity test on unit per established procedures

Follow routine tests inspect unit nameplate, stamp impedance value on nameplate, and secure nameplate to tested unit

Perform visual inspection on interior of unit upon completion of testing

Perform minor maintenance of test equipment

Perform special routine tests when required

Perform all responsibilities of the Inspector, including, but not limited to:

Perform visual inspection of units throughout the assembly process per established procedures

Perform the following tests as required per established procedures: ratio, resistance, leak, continuity, control box, insulation resistance, regulator sub-assembly, regulator modification, regulator run-in

Apply decals and stencils to exterior of unit and perform paint mileage check as required

Assist Engineering and Manufacturing in identifying and resolving shop floor problems

Complete various company forms to communicate inspection status and other information and to document inspection results per established procedures

Collect various types of data per established procedures as required

Qualification

Electrical testingManufacturing experienceAC/DC fundamentalsVisual inspectionData collection

Required

High school graduate or GED equivalent from an accredited institution

Minimum of 1 year of manufacturing experience

Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc

No relocation benefit is being offered for this position. Only candidates within a 50-mile radius of the work location will be considered. Active-Duty Military Service member candidates are exempt from the geographical area limitation

Preferred

Education in AC/DC fundamentals or completion of electricity coursework from an accredited institution or a minimum 1 year of experience in electricity