Apply on Employer Site

SpaceX · 3 days ago

Mechanical Designer, Automation & Controls (Starship Launch Pad)

Cape Canaveral, FL

Full-time

Onsite

Entry, Mid Level

2+ years exp

SpaceX was founded under the belief that a future where humanity is out exploring the stars is fundamentally more exciting than one where we are not. They are seeking a Mechanical Designer for Automation & Controls to help develop the next generation of launch pads, focusing on bridging system architecture and build through detailed design and documentation of electrical and mechanical systems.

Advanced MaterialsAerospaceManufacturingNational SecuritySpace Travel

Growth Opportunities

No H1B

U.S. Citizen Only

Responsibilities

Detail electrical schematics in collaboration with automation & controls engineers who architect the systems

Perform conduit fill calculations and initial sizing of conveyances

Create CAD models and drawings of conduits, control panels, bracketry, and related access provisions

Perform basic structural analysis and use best practices to ensure designs are sufficiently robust for the challenging environment of the launch pad

Translate designs into planning as the basis for install in the field

Documentation of designs as well as best practices

Qualification

3D CAD softwareElectrical schematicsInstrumentationControl systemsWeldments designNECNFPA codesCommunicationProblem-solvingTeam collaborationFast-paced environment

Required

Bachelor's degree in a science or engineering discipline; or 2+ years of professional experience in designing mechanical, fluids, or electrical systems in lieu of a degree

Willing to work extended hours and weekends as needed

To conform to U.S. Government export regulations, applicant must be a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (aka green card holder), (iii) Refugee under 8 U.S.C. § 1157, or (iv) Asylee under 8 U.S.C. § 1158, or be eligible to obtain the required authorizations from the U.S. Department of State

Preferred

Bachelor's degree in a science or engineering discipline

Experience modeling with 3D CAD software (e.g. NX/Unigraphics, Catia, SolidWorks, Fusion 360)

Familiarity with design of weldments and sheet metal structures

Experience using EPlan

Knowledge of NEC, NFPA 79 codes

Experience designing and installing instrumentation and control systems in hazardous areas (NFPA 70 Section 500 installations); Class 1, Division 1 and Division 2 environments or IEC equivalence

Capable of solving problems with little to no supervision on schedule as an individual or as a member of an integrated team

Excellent communication skills, both written and verbal

Experience in fast-paced, demanding iterative design and manufacturing environments