Apply on Employer Site

Eaton · 1 day ago

Tester II - 2nd Shift

Irvine, CA

Full-time

Onsite

Mid Level

$25/hr - $26/hr

3+ years exp

Eaton is a company that values creativity and innovation, and they are seeking a Tester II for their IS AER FMC division. The role involves performing bench testing of various parts, subassemblies, and completed units while ensuring compliance with safety and quality standards.

Electric Vehicle

No H1B

U.S. Citizen Only

Responsibilities

Perform bench work requiring use of simple limit direct reading gauges and meters

Build / fabricate own setup operations on less complicated test systems

Connect products to be tested to test equipment, monitor gauges and meters, verify and record results

Comply with all safety requirements, including proper use of personal protective equipment and operation of equipment in a safe and competent manner. Understand and meet all departmental safety objectives and goals. Keep assigned work-area clean, organized, and orderly per 5S standards

Perform Lean Initiatives including Continuous Improvement

Lead and interpret blueprints & schematics

Qualification

Fuel TestingHydraulic TestingPneumatic TestingBlueprint ReadingContinuous ImprovementSafety PracticesMath SkillsDetail OrientedWorks Independently

Required

High School Diploma or GED from an accredited institution is required

Minimum of three (3) years' work experience in Fuel, Hydraulic and/or Pneumatic Testing is required

Must be authorized to work in the US without company sponsorship

No relocation provided. Candidates must reside within 50 miles of Irvine, CA in order to be considered. Active Duty Military Service member candidates are exempt from the geographical area limitation

This position requires use of information which is subject to the International Traffic in Arms Regulations (ITAR). All accepted applications must be U.S. Persons as defined by ITAR (U.S. citizen, U.S. Permanent Resident, Political Asylee, or Refugee)

Knowledge of simple math including the use of addition, subtraction, multiplication, and division of whole numbers

Ability to use direct reading and fixed gauges

Able to read blueprints and schematics

Detailed Oriented

Works Independently

Continuous Improvement

Follow Safety Practices & Procedures

Ability to lift up to 50lbs