Apply on Employer Site

Hexcel Corporation · 11 hours ago

Acousti-Cap Fabricator CG3

USA - AZ - Casa Grande

Full-time

Onsite

Entry Level

$25/hr - $27.31/hr

1+ years exp

Hexcel Corporation is a global leader in advanced composites technology and manufacturing of composite materials. They are currently seeking an Acousti-Cap Fabricator for their Casa Grande, AZ location, responsible for setting up and operating equipment for acoustical panel fabrication and ensuring product quality throughout the process.

AerospaceIndustrial

No H1B

U.S. Citizen Only

Responsibilities

Sets up and operates all equipment associated with the preparation of core blanks for acoustical insertion and cap stabilization processing equipment, lay out and processing of acoustical panels

Performs a wide variety of tasks associated with the acoustical panel and aircraft engine blanket fabrication. Tasks include set up, measurement, adjustment, regulation and control of all processes required to prepare core for acoustical insertion, control of insertion depth and consistency, control of dipping processes, measurement of flow impedance. Tasks include frequent use of computers to input, analyze and retrieve data

Sets up and adjusts core edge prep machine, core slotting machine for quality of drainage slots. and septum insertion machine for depth and quality of insertion. Adjusts dipping process for depth of adhesive dip and determines time of dipping and drain

Measures air flow impedance/Rayl value of septumized core using the flow testing equipment

Adjusts oven temperature and loads oven with dipped core

Verifies that resins, solvents, and adhesives are within required operating parameters as applicable to each production machine. Determines from M.O., the material to be processed and results to be achieved

Adjusts machine temperature speed and air pressures

Measures and/or checks material visually and/or physically to determine quality of process. Performs close range visual inspection of mesh caps and insertion depths. Visually inspects final product, as defined by visual aids, for shadow rings, holes, tears or debris in mesh caps, and alignment of cells between panels. Inspects and presents to internal customers products that meet or exceed the product specifications

Monitors processes to ensure product is being built per WCI’s and Job Routers. Utilizes SPC where required

Operates other equipment as needed

Qualification

Manufacturing experienceTape measure proficiencyComputer data entryDocument interpretationProblem-solving

Required

High School diploma or general education degree (GED) or equivalent

Minimum of one year experience required preferably in manufacturing. Minimum of 6 months manufacturing experience in the Hexcel Casa Grande facility may substitute in lieu of one year experience

Must be proficient in use of tape measure and ruler

Basic working knowledge of computer data entry function required

Ability to read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals

Ability to write routine reports and correspondence

Ability to speak effectively before groups of customers or employees of organization

Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals

Ability to compute rate, ratio, and percent and to draw and interpret bar graphs

Ability to apply common sense understanding to carry out instructions furnished in written, oral, or diagram form

Must be able to deal with problems involving several concrete variables in standardized situations

Eligible candidate must be a: U.S. citizen, U.S. national, person lawfully admitted for permanent residence, temporary resident under sections 210(a) or 245(A) of the Immigration and Nationality Act, person admitted in refugee status, or person granted asylum